Filter
Top Products
ME003-01 09/04/2014
3
1. Unpack your fan and check the contents. Do not discard the box. If warranty replacement or repair
is ever necessary, the fan should be returned in its original packaging. Remove all parts and hard-
ware. Do not lay the motor housing on its side; the decorative casing may shift.
2. Examine all parts. You should have the following:
Tools and Materials Required
1. Mounting Bracket
2. Motor
3. Motor Housing
4. Blade Irons
5. Blades
6. Parts Pack Containing:
a. Mounting bracket hardware (extra screw
and washer, wire nuts, extra motor screw,
and washer)
b. Noise isolators, blade nuts, blade screws
Note: Some Revolutions fan models will have slightly different parts than shown here,
depending upon the model. Basic installation procedures are similar for all fan models.
• Phillips screw driver
• Flat Head screw driver
• Adjustable pliers or wrench
• Step Ladder
• Wire Cutter
• Electrical tape
Unpacking the Fan
2
1
3
4
5
6
Assessing the Installation Location
,8 Meters
from blade tip
to nearest wall
or obstruction
2,1 Meters
from bottom
edge of blade to
the oor
CAUTION
To reduce the risk of injury to
persons, install fan so that the blade
is at least 2,1 m above the floor.