Hunter Fan 43540-01 Landscape Lighting User Manual


  Open as PDF
of 6
 
ForHunterOriginalCeilingFansOnly:
1. Disconnect power to the ceiling fan by turning off the circuit breakers both to the
outlet box and to its associated wall switch location.
2. Remove the switch housing cover by unscrewing the two screws.
Note: Save the switch housing cover and two screws should you choose to remove
the light fixture in the future.
3. Feed the two wires from the light fixture through the center hole in the switch hous-
ing cover (included with the light fixture).
4. Remove the wire nut from the black/white wire in the switch housing. Use this wire
nut to connect the black/white wire from the switch housing to the black wire from
the light fixture. Remove the wire nut from the white wire in the switch housing.
Use this wire nut to connect the white wire from the switch housing to the white
wire from the light fixture.
5. Attach the light fixture to the switch housing with the two screws, included with the
light fixture, aligning the holes in the light fixture, switch housing cover, and switch
housing. Securely tighten the two screws.
WARNING: Improper installation could cause the light fixture to fall.
Continue with Step 8.
Step 2
Steps 3-5
For Hunter Original
Ceiling Fans Only:
Switch
Housing
Switch
Housing
Cover
Light
Fixture
Switch
Housing
Cover (in-
cluded with
the light
fixture)
For Hunter Original
Ceiling Fans Only:
 previous