Hunter Fan 42641-01 Outdoor Ceiling Fan User Manual


 
7
42641-01•09/13/07 HunterFanCompany
4 • Hanging and Wiring the Fan
Single Switch Wiring
Dual Switch Wiring
Wire
connector
4-1.Raisethefanandaligntheslotsinthecanopywiththehooksonthe
ceilingplate.
Note: Tohangthefan,youmusttiltthecanopytoanalmostvertical
positionsothatthecanopyslotssitontheceilingplatehooks.
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Wallswitchesarenotincluded.Selectanacceptablegeneral-useswitchin
accordancewithnationalandlocalelectricalcodes.
4-2. Makesurethepowertotheoutletboxandassociatedwallswitch
locationisstillOFF.
4-3.Toconnectthewires,holdthebaremetalleadstogetherandplacea
wireconnectoroverthem,thentwistthewireconnectorclockwise
untiltight.
4-4.Connectthebareorgreengroundwired(grounded)fromtheceiling
to the green ground wire (grounded) from the ceiling plate and the
greengroundwirefromthefan.
4-5.Connectthewhitewire(ungrounded)fromtheceilingtothewhite
wired(ungrounded)fromthefan.
4-6.Connecttheremainingwiresasfollows:
Single Switch Wiring:
• eblackwirefromtheceilingtotheblackandtheblack/white
wirefromthefan.
Dual Switch Wiring:
• eblackwirefromtheceilingtotheblackwirefromthefan.
• eblack/whitewirefromthefantothewireforthewallswitch.
CAUTION:Besurenobarewireorwirestrandsarevisibleaftermaking
connections.
4-7 Turnthesplicesupwardandpushthemcarefullybackthroughthe
ceilingplateintotheoutletbox.
4-8 Spreadthewiresapart,withthegroundedwiresononesideofthe
outletboxandtheungroundedwiresontheothersideoftheoutlet
box.