Hunter Fan 41873-01 Outdoor Ceiling Fan User Manual


 
10
Hunter Fan Company 41873-01 • 11/18/05
11
41873-01 • 11/18/05 Hunter Fan Company
Steps 7-1 – 7-4
Housing
Assembly
Screw
7 • Installing the Light Fixture
Upper
Switch
Housing
WARNING: Use only the light xture supplied with this fan model.
7-1. To attach the upper switch housing, partially install two #6-32 x
3/8” housing assembly screws into the switch housing mounting
plate.
7-2. Feed the upper plug connector through the center opening of the
housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
7-4. Turn the housing counterclockwise until the housing assembly
screws are rmly situated in the narrow end of the keyhole slots.
Install the remaining #6-32 x 3/8” screw into the housing. Tighten
all three screws rmly.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light xture falling.
7-5. read the wires from the lower switch housing assembly through
the center hole.
7-6. To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only t together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.
7-7. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower switch
housings. Attach the lower switch housing to the upper switch
housing with three housing assembly screws. Note: You will need
to rotate the blade irons out of the way for each screw.
Lower Switch
Housing
Plug
Connector
Steps 7-6 – 7-7
Housing
Assembly
Screw