HTC Z4824BF Lawn Mower User Manual


 
English-44
MAINTENANCE
EZT belt
To replace EZT (E-Series Zero Turn Transaxle) belt
Park the mower on a level surface. Engage the
parking brake.
EZT belt removal
NOTE: Be careful not to damage the fan blades on the
EZT´s as this can affect cooling or damage the EZT´s
• Remove the deck belt (see to replace deck belt in
this section of the manual).
• Unplug clutch from wiring harness. Remove bolt from
center of clutch and slide clutch off of engine shaft.
• Create slack in the belt by removing the spring on the
pump idler arm.
• The belt should now be able to be removed from the
engine pulley and EZT pulleys.
Belt installation
Wrap the EZT belt around the EZT pulleys
Route the belt around the inside of the idler pulley.
Now you can wrap the belt around the engine
pulley.
Reattach the spring on the pump idler arm.
Install clutch on to engine shaft (pulley side down)
make sure key is installed and align the clutch
anti-rotation tab into slot on clutch. Secure clutch,
install wire.
Reinstall the deck belt onto the electric clutch belt
(see to replace deck belt in this section of the
manual).
Transaxle belt