Filter
Top Products
CONTROLS
English-23
4
1
/
2
4
3
1
/
2
3
2
1
/
2
2
1
1
/
2
Lifting Lever for the Mower Deck
The deck cutting height is achieved with the foot
pedal. To lift the deck, press the foot pedal forward.
To lower the deck, apply pressure to the top side
of the foot pedal and allow the pedal to pivot while
allowing the lift arm to rotate to the rear of the unit.
To stop at the desired cutting position, rotate the pedal
down into the notch in the height plate. The cutting
height range is from 1½" (38mm) to 5" (127mm) in
½" (13mm) increments. The heights are measured
from the ground up to the blade tip with the engine not
running.
Accessories
For mulching, there is a BioClip attachment available.
The BioClip is mounted underneath the mower deck
and includes a discharge cover and blades.
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all four
tires is the same 15 psi (1 bar).
8011-753
Cutting height pedal