Filter
Top Products
OPERATION
Husqvarna - 27
8011-527
Start conditions
8011-753
Raise the mower deck
Starting the Engine
Sit on the seat.1.
Raise the mower deck by pulling the lifting 2.
lever backward to the locked position
(transport position).
Activate the parking brake.3.
Before Starting
Read the sections “Safety Instructions” and •
“Controls” before starting the machine.
Perform the daily maintenance before starting •
(see Maintenance Schedule in the Maintenance
section).
Check that there is sufcient fuel in the fuel tank.•
Adjust the seat to the desired position.•
The following conditions must be fullled before •
the engine can be started:
The driver must be seated on the seat.•
The blade switch for engaging the mower blades •
must be depressed.
The parking brake must be on.•
Both steering controls must be in the locked •
(outer) neutral position.
Roll bar and safety belt
Operate the unit with the roll bar in the raised and
locked position and use the seat belt. There is no
rollover protection when the roll bar is down. If it is
necessary to lower roll bar, do not wear the seat belt.
Raise the roll bar as soon as clearance permits.
8011-464
Roll bar in upright position
WARNING!
The seat belt must be used when the
roll bar is in upright position.