Filter
Top Products
6. In-
stall drive wheel to axle using pin
hole nearest to lower handles as shown. Insert 2” cotter pin through wheel and through axle. Bend with pliers to prevent pin from
falling out. Next slide the wheel spacer and then the outer wheel and cotter pin through the axle only.
8. NOTE: BEFORE INSTALLING GAUGE AND UPPER
HANDLES TO HANDLE SHAFT, UPPER HANDLES FEA-
TURE THREE POSITIONS FOR OPERATOR’S COM-
FORT. You can select lower, middle or upper positions for best
fit to the operator. Insert 2¾” bolt through the Gauge, then upper
handle and finally through handle. DO NOT TIGHTEN
LOCKNUT YET.
9. Insert pivot rod into shut off plate as shown. Turn to lock in
place.
10. Insert other end of pivot rod into pivot and bracket assembly
as shown. Turn to lock in place.
PAGE 3
7. Install inner coast wheel to axle, then wheel spacer and then the outer coast
wheel and install cotter pin using outside hole. As shown, insert 1” cotter pin
through axle (not thru the wheel). Bend with pliers to prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO WHEELS.