Filter
Top Products
4. Install gear box by inserting the pinion shaft into hole in
center of hoppers bottom. The word “FRONT” on the gearbox
must point to Front of the hopper.
3. Install impeller onto pinion shaft. Insert 1/8” x 1 ” cotter pin
through impeller then through pinion shaft. Use hole nearest gear box.
Spread cotter pin to prevent from falling out.
5. A - Install lower handles onto axle to both sides as shown.
Now insert 1 1/2” bolt through first hole in lower handle. Then
through frame brace. NOTE: Dimples on frame brace must be
facing toward gear box as shown. Next into threaded connector in
cross brace. DO NOT TIGHTEN YET. B - Next insert 1 1/2”
bolt through other end of frame brace and through second hole in
frame install locknut. DO NOT TIGHTEN YET. C - Now in-
sert 2 1/4” bolt through second hole in lower handle and through
first hole in frame.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
PAGE 2