Hearth and Home Technologies GFK-210-C Blower User Manual


  Open as PDF
of 7
 
2 Hearth & Home Technologies • GFK-210-C Blower System Instructions 2201-938 Rev. E • 9/12
Figure 4. Remove Access Cover
Figure 5. Attach Blowers to Access Cover
Figure 3. Remove Blower Brackets
NOTE: Install the blower using the access panel located on
the back side of the appliance.
4.0 INSTALLING THE BLOWER (Metal Inserts)
1. Remove factory-installed blower brackets by removing
four screws. Brackets are only used for the FireBrick
inserts. See Figure 3.
2. Remove appliance from wall.
3. Remove access panel by removing four screws. See
Figure 4.
4. Screw blowers to access panel on rear of insert with
four screws. See Figure 5.
5. Plug the blower cord into the blower receptacle. Con-
nect the white, black, and green spade connectors
from blower cord harness to each blower. See Figure
1 and Figure 7.
6. Bundle and zip tie any wires to keep them from contact-
ing the fan blades. See Figure 7, Detail A.
7. Reinstall access panel.
 previous next