Hearth and Home Technologies GFK-210-C Blower User Manual


  Open as PDF
of 7
 
1Hearth & Home Technologies • GFK-210-C Blower System Instructions 2201-938 Rev. E • 9/12
Figure 1. Carton Contents - GFK-210-C
GFK-210-C Blower System
- Installation and Operating Instructions -
1.0 INTRODUCTION
The GFK-210-C Blower System has been designed to
circulate room air through the replace to enhance heat
output. The GFK-210-C blower system operates on 120
VAC, 60 Hz power. This is available through a receptacle
in the factory installed power cord assembly. The power
cord is located in the controls compartment of the replace.
An optional variable speed control is available for use
with the blower system to provide quiet forced air ow at
the desired speeds. A temperature sensor switch, which
automatically turns the blower ON/OFF, is also provided
with this kit. See Figure 2 and Section 8.0.
NOTICE: The variable speed control and temperature
sensor switch are not used with some remote control
systems.
3.0 INSTALLATION PRECAUTIONS
The GFK-210-C Blower Kit is tested and safe when installed
in accordance with this installation manual. It is your respon-
sibility to read all instructions before starting installation and
to follow these instructions carefully during installation to
assure maximum benet from, and safe operation of, the
blower.
This blower is carefully engineered and must be installed
only as specied. If you modify it or any of its components,
you may cause a re hazard and will void the WARRANTY.
In addition, such action may void the coverage provided
by the owner's home insurance.
CAUTION: All wiring should be done by a qualied electri-
cian and shall be in compliance with local codes and with
the National Electric Code ANSI/NFPA NO. 70-current (in
the United States), or with the current CSA C22.1 Canadian
Electric Code (in Canada).
CAUTION! DO NOT connect 110-120 VAC wiring to the
gas control valve of the replace.
WARNING! Risk of Shock! Turn electrical power off at
the circuit breaker before beginning this installation.
CAUTION! Do not install a damaged blower kit.
VARIABLE SPEED CONTROL
WING
NUT
CONTROL
KNOB
CONTROL
NUT
TEMPERATURE
SENSOR
SWITCH
OPTIONAL
RHEOSTAT/TEMPERATURE
SENSOR ASSEMBLY
Figure 2. Carton Contents - SRV2206-800
BLOWER CORD
FAN
BRACKETS
2.0 CHECK CONTENTS OF SHIPPING CARTON
Compare CONTENTS OF CARTON in Figure 1 with the
actual parts received. If any parts are missing or damaged,
contact your dealer before starting installation.
next