Filter
Top Products
953910KG141004
MAINTENANCE
1.57
1.57
3D3122A
x + 3 - 8mm
x
4
3
2
1
1. Wheel centre height
2. Tyre
3. Direction of forward travel
4. Track-rod assembly
EVERY 500 HOURS
Renew the engine air cleaner filter: Check the condition of the air cleaner
hoses. Replace any hose which is damaged and tighten the connections, refer -
ENGINE MANUAL.
Renew the engine fuel filter element: Refer - ENGINE MANUAL.
Check electrical system: Inspect all electrical connections and cables and replace any which are damaged
or corroded. Spray a good quality water inhibitor on to exposed connections to prevent moisture ingress.
Check rear wheel alignment: To prevent excessive tyre wear and ensure safe machine operation, the rear
wheels must be correctly aligned to ‘toe - in’ by 3 - 8mm.
Set the rear wheels in the straight ahead position. Measure and compare the distance between the front
sidewalls and the rear sidewalls at the wheel centre height. The distance between the front sidewalls must
be set 3 - 8mm less than the distance between the rear sidewalls.
To adjust the alignment of the rear wheels, first back off the left hand and right hand locknuts on the track
rod assembly. (Left hand locknut is a left hand thread). Rotate the track rod to achieve the correct
‘toe - in’ as described above and tighten the locknuts securely.
Continued.
ENGINE
ENGINE