Filter
Top Products
6. Install the 2 bolts and 2 locknuts previously removed
in the remaining holes in the wheel halves and
tighten. Remove the 2 long screws or bolts and
replace them with 2 bolts and 2 locknuts (Figure 31).
7. Install the wheel to the pivot arm with the bolts,
a spacer, and a locknut. Ensure that the spacer is
positioned between the wheel hub and the pivot arm
(Figure 31).
Controls System
Maintenance
Adjusting the Blade Brake
Cable
Whenever you install a new blade brake cable assembly
or replace the belt, adjust the blade brake cable.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Figure 12).
3. Remove the fuel tank from the tank bracket.
Note: You do not need to disconnect the fuel line
from the fuel tank.
4. Reset the cable adjuster on the handle so that 1/4
inch (6 mm) of the threads show, then tighten the
nut (Figure 32).
Figure 32
1. Adjuster
3. 1/4 inch (6 mm) of threads
2. Nut
5. Loosen the cable clamp screw until the brake cable
conduit slides (Figure 33).
22