Filter
Top Products
How to sharpen and balance the cutterbar: A slightly
worn cutterbar may be re-sharpened. All cutting edges must
be sharpened equally to ensure balance. Sharpen the cutter-
bar every 25 mowing hours or more frequently if conditions
require. Remove the cutterbar from the mower and clean
using a brush and water. Inspect the cutterbar for signs of
damage.
WARNING - PREVENT ACCIDENTS: DO NOT use a
damaged or excessively worn cutterbar.
Sharpen all the cutting edges with a flat file to restore the
original cutting edges.
Ensure that the cutterbar is balanced. Use a screw driver
with a round shaft to support the cutterbar through its centre
hole. Hold the cutterbar horizontal and then release. A bal-
anced cutterbar will remain horizontal. If the cutterbar is
not balanced the heavy end will rotate downward. Sharpen
the heavy end until the cutterbar is correctly balanced.
MAINTENANCE
401001EB100398A
1.31
1.31
CUTTERBAR
Continued.
30 -45
CS040
CS025
CS026