Filter
Top Products
The cutting height of your mower has been set at the
highest position (1). If you prefer a lower cut follow
these instructions:
a. Turn the petrol tap to the off position and where
fitted the vent screw.
b. Disconnect the spark plug lead.
c. Tilt the mower to its side. (Keeping the carburet
-tor uppermost).
d. Remove flexiblade from cutting disc.
e. There are 3 different cutting height settings.
Position one length of flexiblade into the desired
cutting height setting. Ensure that a second length
is positioned in the corresponding cutting height
on the opposite side of the cutting disc.
If using spare reel of flexiblade, cut to the length of 200mm and fit as
above.
Drain the fuel by running the engine until the fuel tank is empty and the
engine stops. Remove the spark plug lead and allow the engine to
cool. Turn the mower on its left hand side and ensure that the carburet-
tor is uppermost.
Wearing protective gloves remove flexiblade and replace with new.
To prevent accidents, thoroughly inspect the area and remove all
objects which when contacted by the mower cutterbar could become
dangerous projectiles. Inspect the area for hidden obstructions which
when contacted by the cutterbar could risk health and safety or result
in damage to the mower. Remember the location of these obstructions
and ensure that you mow around them.
1.16
OPERATING THE MOWER
1
3
2
2
1 = HIGH
2 = MID
3 = LOW
HAY-G00143-A
Adjusting the Cutting Height
305113
Before Mowing
Flexiblade Replacement
111-1519 (A) 28/1/08 4:44 pm Page 1.16