Filter
Top Products
Collecting Grass
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing the
Side Discharge Chute) before bagging the clippings.
The cutterblade is sharp; contacting the
cutterblade can result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
Installing the Grass Bag
1. Remove the mulch plug (Figure 29).
Figure 29
2. Route the starter rope around the lower rope guide
(Figure 30).
Figure 30
Note: The lower rope guide releases the starter
rope when you pull the recoil start handle.
3. Insert the grass bag handle into the grooves at the
top of the mower (Figure 31).
Important: The mower has a safety switch that
prevents you from starting the mower unless
you rst install the grass bag securely on the
mower.
Figure 31
Removing the Grass Bag
1. Route the starter rope around the lower rope guide
(Figure 32).
Figure 32
2. Lift the grass bag handle out from the grooves at
the top of the mower and remove the bag from the
mower (Figure 33).
Remove grass debris from the grass bag
immediately after use and check it’s condition
for signs of damage. A worn grass bag could
allow debris to be thrown at both operator or
bystander resulting in personal injury or death.
To prevent accidents replace a damaged grass
bag immediately.
14