Filter
Top Products
Checking the Engine Oil Level
Service Interval: Before each use or daily
1. Remove the dipstick, wipe it clean, and fully install
the dipstick (Figure 17).
Figure 17
2. Remove the dipstick and check the oil level
(Figure 17). If the oil level is below the Add mark
on the dipstick, slowly pour oil into the oil ll tube
to raise the oil level to the Full mark on the dipstick.
Do not overll. (Max. ll: 0.6 l, type: SAE 30
detergent oil)
3. Install the dipstick securely.
Adjusting the Cutting Height
Adjusting the cutting height may bring you into
contact with the moving cutterblade, causing
serious injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your ngers under the housing
when adjusting the cutting height.
If the engine has been running, the exhaust
guard will be hot and can severely burn you.
Keep away from the hot exhaust guard.
Adjust the cutting height as desired. Set all four wheels
to the same height.
Note: To raise the mower, move all 4 cutting height
levers forward; to lower the mower, move them all
rearward.
Figure 18
Adjusting the Upper Handle
Height
You may raise or lower the upper handle to a position
comfortable for you.
Note: You cannot raise the upper handle higher than
the angle of the lower handle.
1. Loosen the upper handle knob (Figure 19).
Figure 19
2. Move the upper handle to the desired position
(Figure 20).
11