Filter
Top Products
Page 9SKU 99623 For technical questions, please call 1-800-444-3353.
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Inspection, Maintenance, and
Cleaning
BEFORE EACH USE, inspect the 1.
general condition of the Spreader.
Check for loose screws, misalign-
ment or binding of moving parts,
cracked or broken parts, and any
other condition that may affect its
safe operation.
AFTER USE,2. Never leave material in
the Spreader. Pour leftover material
back into its bag/container and seal the
bag/container tightly.
CLEANING AND STORAGE: wash 3.
thoroughly to remove all material in the
Spreader. Allow the unit to dry. Then
store the unit indoors out of children’s
reach.
NOTE: This Spreader does not require 4.
lubrication.
PLEASE READ THE
FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS
PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER
THE MANUFACTURER OR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE
BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY
REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.
IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED
AND LICENSED TECHNICIANS, AND NOT BY THE BUYER.
THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT
OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
TROUBLESHOOTING
Problem Possible Cause(s) Possible Solution(s)
Unit will not release material. Improper use of Adjust Handle.1.
Improper ow rate setting.2.
Wet, or wrong type of materal.3.
Pull Adjust Handle backward to 1.
release material. Push forward
to stop ow of material.
Make sure Adjust Handle setting 2.
is adjusted to that of material
manufacturer’s recommended
setting.
Unit is designed only for dry, 3.
powered, and granular material.
Unit releases too much or too little
material.
Improper ow rate setting.1. Make sure Adjust Handle setting 1.
is adjusted to that of material
manufacturer’s recommended
setting.
Follow all safety precautions whenever diagnosing or servicing the Spreader.