Filter
Top Products
Page 7SKU 99623 For technical questions, please call 1-800-444-3353.
one Lock Nut (24).
(See Figure I.)
FIGURE I
HOPPER
(16)
FLAT
WASHER
(48)
LOCK
NUT
(24)
10. Push down on the Adjust Handle (6)
to its lowest position.
(See Figure J.)
FIGURE J
“R” PIN (17)
“R” PIN
(17)
WING
NUT
(10)
LOCK NUTS
(24)
PUSH FORWARD.
IMPELLER MUST TURN
IN THIS DIRECTION.
ADJUST
HANDLE
(6)
PINION
SHAFT
11. Adjust the position of the two Lock
Nuts (24) on the Control Rod (25),
making sure the holes at the bottom
of the Hopper (16) line up with the
holes in the Shut Off Plate (27) prop-
erly. (See Figures I and J.)
Pull up on the Adjust Handle (6) to its 12.
upper position, making sure the holes
in the Hopper (16) and the holes in the
Shut Off Plate (27) are 100% open.
(See Figure J.)
Adjust the position of the Wing Nut 13.
(10). By doing so, you are able to con-
trol the size of the holes you need.
(See Figure J.)
Insert the “R” Pin (17) into the Pinion 14.
Shaft on the Gear Box and Axle As-
sembly (39). Make sure the Impeller
(42) is turning in the correct direction as
indicated by the arrow in the illustration.
(See Figure J.)
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
including all text under
subheadings therein before
assembly or use of this product.
Before operating the Spreader make 1.
sure to wear ANSI-approved safety
impact glasses, NIOSH-approved dust
mask/respirator, and heavy duty work
gloves.
Remove the Screen (14) on the Hopper 2.
(16) and ll the Hopper with the materi-
al you wish to apply. Do not exceed 50
pounds of material. Then replace the
Screen. (See Figure K, next page.)
Refer to the manufacturer’s recom-3.
mended ow rate (0 to 5, typically
shown on the bag/container of the
material being applied).
Adjust the ow rate on the Gauge and 4.
Lever Assembly (4) to that of the mate-
SHUT OFF PLATE
(27)