Filter
Top Products
Page 8SKU 95964 For technical questions, please call 1-800-444-3353.
Oil Instructions
Filling Engine Oil:
Note: Check oil level only when Engine is stopped and on a level surface.
Wipe the immediate surrounding area of the Oil Fill Cap. Unscrew and remove 1.
the Oil Fill Cap. Wipe the dipstick connected to the Fill Cap clean, reinsert briey,
remove and examine.
If the oil on the dipstick indicates that Engine oil level is low, ll to the edge of the 2.
oil ller hole with the appropriate oil. A pressure feed can (not included) is recom-
mended. See Harbor Freight Tools’ SKU 36629. The Engine takes approximately
20 uid ounces of oil in total.
Make sure to screw the Oil Fill Cap rmly back into place.3.
To Change Oil:
Start and run Engine until it is warm, then turn the Engine off.1.
Place a pan capable of holding more than 20 ounces of oil underneath Oil Drain 2.
Plug to catch oil.
Remove Oil Drain Plug, Oil Fill Cap and washer.3.
Allow oil to drain completely, then reinstall washer and Oil Drain Plug.4.
Fill with about 20 ounces of recommended oil. 5.
Note: Dispose of used oil and oil rags in a manner consistent with State and Local laws
and ordinances.
Fuel Instructions
Note: Check fuel level only when Engine is stopped and on a level surface.