Filter
Top Products
SKU 95619 For technical questions please call 1-800-444-3353 Page 10
Operation
Pick up the Spray Gun (37) and point it in a safe direction. Squeeze the Spray Gun 1.
Trigger until all internal air is released, and a steady ow of water comes out. Then
release the Spray Trigger.
2. Turn the Fuel Valve (D) to the open position (see engine photo).
Turn the Speed Control Lever (C) all the way to the left, or fast position (see photo).3.
Move the Choke Lever (B) all the way to the left, or closed position (see photo).4.
Pull the Starting Handle (A) (shown above in photo) lightly until you feel 5.
resistance. Then, pull it completely out. The engine should start up. If the en-
gine does not start after a few tries, refer to Engine Manufacturer’s Trouble-
shooting Tips. Slowly release the Starting Handle.
Adjust the Speed Control Lever (C) for the desired speed and subsequent 6.
output water pressure. Open the Choke Lever (B) to the right.
Hold the Spray Gun (37) with both hands and begin spraying. Do not allow 7.
the engine to run for more than three minutes without spraying.