Filter
Top Products
SKU 94593 For technical questions, please call 1-800-444-3353 Page 3
7. Use eye protection. Always wear ANSI-approved impact safety goggles.
Wear a full face shield if you are producing flying wood chips.
8. Do not overreach. Keep proper footing and balance at all times. Do not reach
over or across running machines.
9. Maintain tools with care. Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and changing accessories.
Inspect tool air hoses periodically and, if damaged, have them repaired by an
authorized technician. The handles must be kept clean, dry, and free from oil
and grease at all times.
10. Disconnect air line. Unplug air line from the tool when not in use.
11. Avoid unintentional starting. Be sure the switch is in the Off (and locked)
position when not in use and before plugging air line in. Do not carry any tool
with your finger on the trigger, whether it is plugged in or not.
12. Stay alert. Watch what you are doing, use common sense. Do not operate
any tool when you are tired.
13. Check for damaged parts. Before using any tool, a part that appears
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment and binding
of moving parts; any broken parts or mounting fixtures; and any other
condition that may affect proper operation. Any part that is damaged should
be properly repaired or replaced by a qualified technician. Do not use the tool
if any switch does not turn On and Off properly.
14. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use
accessories intended for use with this tool. Approved accessories are
available from Harbor Freight Tools.
15. Do not operate tool if under the influence of alcohol or drugs. Read
warning labels if taking prescription medicine to determine if your judgment or
reflexes are impaired while taking drugs. If there is any doubt, do not operate
the tool.
16. Maintenance. For your safety, service and maintenance should be
performed regularly by a qualified technician.
17. Use tools with both hands when required. Many tools such as chain
saws, drills, routers, etc., require the use of both hands when operating. This
helps maintain tool stability and keeps hands away from the working area of
the tool.
18. Compressed air only. Never use combustible gas as a power source.