Filter
Top Products
Page 4For replacement parts, please call 1-800-444-3353.
SKUs
91839, 91840
& 92199
Assembly
Note: Because of the weight and size of the Log Splitter, assembly should be done with the
help of another person.
Attaching the Tires
Refer to the Assembly Drawing on page 9 and FIGURE 1 on page 5.
1. Position the Tires (48) next to each of the Axles located on the bottom of the Oil Tank
Assembly (10). The Tires (48) come completely assembled.
2. Make certain to pack the bearings as explained in the included insert.
3. Put a Seal (59) and Bearing (49) on the Axle and then put the Tire (48) on the Axle.
4. Follow the
Bearing Packing Instructions
as explained on the last page of this
manual. With each Tire (48) in place, add a Washer (50) and a Spindle Nut (51) onto
the ends of the Axles. Tighten the Spindle Nuts (51) to 20-25 ft. pounds, and turn each
tire several times to seat the bearing. Back off the Spindle Nut (51) one half turn. Insert
a Cotter Pin (25) through both the Axle and the Spindle Nut (51) and bend the end of
the Pin back to hold it in place. Lastly, tap on a Wheel Cap (61).
The Tire (48) assembly is now complete. Note: It may be necessary to reset the wheel
bearings after the Log Splitter has been towed.
The wheel manufacturer states the maximum speed is not to exceed 40 MPH. The tires
are DOT approved for public roads; however, this item is not for use on public roads or
highways.
Unpacking
When unpacking, check to make sure the parts listed on page 9 are included. If any
parts are missing or broken, please call Harbor Freight Tools at the number on the cover of
this manual as soon as possible.
21. This equipment must never be used in any sealed structure. Carbon mon-
oxide is produced during operation and is DEADLY in a closed environment.
Early signs of carbon Monoxide poisoning resemble the flu, with headaches,
dizziness, or nausea. If you have these signs, the tool may not be working prop-
erly or is improperly vented, get fresh air immediately.
22. Never split a log that contains any foreign materials.
23. WARNING: The brass components in this product contain lead, which is a chemical
known to the State of California to cause cancer and birth defects or other reproductive
harm. (California Health & Safety Code § 25249.5,
et seq.
)
24. People with pacemakers should consult their physician(s) before using this prod-
uct. Electromagnetic fields in close proximity to a heart pacemaker could cause
interference to or failure of the pacemaker.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
REV 11/04