Filter
Top Products
Page 11For technical questions, please call 1-800-444-3353.SKU 68333
cleaning efciency. Turn on the water source and
power, and rinse off all detergent completely.
8. Hold the Water Gun at about a 45° angle and
steadily sweep the stream back and forth; if a
severe, head-on angle is used, dirt may imbed
in the surface being cleaned. Follow a steady,
consistent pace during cleaning; this will help prevent
stripes or discoloration afterwards. If streaking or
uneven cleaning is noted at the end of a project,
go over the edges of the streaks with a wide fan
pattern to help blend these lighter areas in.
9. If several different surfaces are to be cleaned,
be careful not to damage any of the less solid
surfaces while trying to clean the harder ones.
This is especially a concern when cleaning tile and
grout, bricks and mortar, or stones and mortar.
10. If wood is being cleaned, be careful to avoid damage.
Wood will usually require resurfacing (Sanding)
and re-coat with a surface protectant (wood, stain,
varnish) after it has dried. Try to avoid leaving water
on a wooden surface; doing so can harm the surface.