Filter
Top Products
SKU 47761 PAGE 9
For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
EXTENSION CORDS
1.
Grounded
tools require a three wire extension cord.
2. As the distance from the supply outlet increases, you must use a heavier gauge
extension cord. Using extension cords with inadequately sized wire causes a serious
drop in voltage, resulting in loss of power and possible tool damage. (See Table A.)
3. The smaller the gauge number of the wire, the greater the capacity of the cord. For
example, a 14 gauge cord can carry a higher current than a 16 gauge cord.
WARNING! Do not use 16 or 18 AWG extension cords on this product.
4. When using more than one extension cord to make up the total length, make sure
each cord contains at least the minimum wire size required. (See Table A.)
5. If you are using one extension cord for more than one tool, add the nameplate
amperes and use the sum to determine the required minimum cord size.
(See Table A.)
6. If you are using an extension cord outdoors, make sure it is marked with the suffix
“W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.
7. Make sure your extension cord is properly wired and in good electrical condition.
Always replace a damaged extension cord or have it repaired by a qualified
electrician before using it. Protect your extension cords from sharp objects, excessive
heat, and damp or wet areas.
AelbaT
)V021(*SDROCREWOPROFEGUAGERIWMUMINIMDEDNEMMOCER
SEREPMAETALPEMAN
)daoLlluFtA(
HTGNELDROCREWOP
52
tee
F
05
teeF
TEEF05REVO
0.61-1.214121
tsumsdroCnoisnetxE
.desuebTON
0.02-1.612101
.serepmadetarehtfo%051tastlovevifo
tpordegatlovenilehtgnitimilnodesaB*
SYMBOLOGY
Table B