Filter
Top Products
SKU 43149 For technical questions, please call 1-800-444-3353. Page 3
Check for damaged parts8. . Before
using any tool, any part that ap-
pears damaged should be carefully
checked to determine that it will oper-
ate properly and perform its intended
function. Check for alignment and
binding of moving parts; any broken
parts or mounting xtures; and any
other condition that may affect proper
operation. Any part that is damaged
should be properly repaired or re-
placed by a qualied technician. Do
not use the tool if any switch does not
turn On and Off properly.
Replacement parts and acces-9.
sories. When servicing, use only
identical replacement parts. Use of
any other parts will void the warranty.
Only use accessories intended for
use with this tool. Approved accesso-
ries are available from Harbor Freight
Tools.
Do not operate tool if under the in-10.
uence of alcohol or drugs. Read
warning labels on prescriptions to
determine if your judgment or reex-
es are impaired while taking drugs. If
there is any doubt, do not operate the
tool.
Maintenance11. . For your safety, main-
tenance should be performed regu-
larly by a qualied technician.
People with pacemakers should con-12.
sult their physician(s) before using
this product. Electromagnetic elds
in close proximity to a heart pace-
maker could cause interference to, or
failure of, the pacemaker.
WARNING: Handling the cord on 13.
this product will expose you to lead,
a chemical known to the State of
California to cause cancer, and birth
defects or other reproductive harm.
Wash hands after handling.
(California Health & Safety Code §
25249.5, et seq.)
Warning: The warnings, cautions, 14.
and instructions discussed in this
instruction manual cannot cover
all possible conditions and situ-
ations that may occur. It must be
understood by the operator that
common sense and caution are
factors which cannot be built into
this product, but must be supplied
by the operator.
UNPACKING
When unpacking, check to make
sure all parts shown on the Parts Diagram
and Parts Lists are present. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353.
PREPARING TO OPERATE
Assembly
Figure 1 Figure 2
1. Turn the lock nut on the stem clock-
wise to loosen (see Figure 1).
Adjust the length of the stem so that 2.
when you stand upright with the tool
held in your hand, the search coil is
level with and about 1/2 to 2 inches
above the ground (see Figure 2).
REV 07f; 09c