Filter
Top Products
20
1.1 PURPOSE AND SCOPE
OF THE MANUAL
These Installation Instructions have been prepared
especially for the purpose of familiarizing installers
and owners of the applicable equipment with the
product's installation requirements. Give serious
consideration to all information and instructions in
the manual, both for safety and for continued reliable
operation of the equipment.
Because of the different recreational vehicle mod-
els and the variations between the models, it would
be extremely difficult, if not impractical, to provide
detailed instructions for every possible installation.
For that reason, instructions and illustrations in this
manual are general in nature. Illustrations are not
intended to serve as detailed installation blueprints.
The installation should comply strictly with all appli-
cable codes, standards and regulations pertaining
to the installation and use of this product. If any
portion of this manual appears to be in conflict with
such codes, standards or regulations, the applicable
codes, standards or regulations must take prece-
dence over the manual.
1.2 SAFETY
Before handling, installing, operating or servicing this
equipment, carefully read the “Notice to Installer”
and “Safety Rules”. Comply with all safety rules to
prevent death, personal injury or damage to equip-
ment and/or property. Stress safety to all installers,
operators and service technicians who work on this
equipment.
1.3 STANDARDS BOOKLETS
Installation, use and servicing of this equipment
should comply strictly with published standards, as
well as the manufacturer's recommendations. The
following standards booklets (latest revision) are
available from the sources indicated:
1. NFPA Standard 501C, “Standard for Recreational
Vehicles,” available from the National Fire
Protection Association, Batterymarch Park,
Quincy, MA 02269.
2. NFPA 70, “NFPA Handbook of the National
Electric Code,” available same as Item 1.
3. ANSI C1-1975 and ANSI 119.2-1975, available
from the American National Standards Institute,
1430 Broadway, New York, NY 10018.
4. ANSI A119.2/NFPA 501C, available from the
Recreational Vehicle Association, 1896 Preston
White Drive, Reston, VA 22090.
5. California Administrative Code, Title 25, available
from the State of California, Documents Section,
P.O. Box 1015, North Highlands, CA 95660.
6. CSA Electrical Bulletin 946, available from the
Canadian Standards Association, Housing and
Constructions Materials Section, 178 Rexdale
Boulevard, Rexdale, Ontario, Canada, M9W 1R3.
1.4 EQUIPMENT DESCRIPTION
Instructions and information in this section pertain
to air-cooled generators. This generator is designed
specifically for installing in recreational vehicles. This
generator operates 120-volts, single-phase, 60-Hertz,
AC electrical loads that require 30.0 amps.
1.5 GENERATOR ENGINE
OPERATING SPEED
The generator’s revolving field (rotor) is driven by a
single-cylinder, four-cycle engine. The generator sup-
plies 120 volts AC at 60 Hertz when the rotor is oper-
ating at 3,600 rpm.
1.6 GENERATOR AC
CONNECTION SYSTEM
The generator is equipped with dual stator power
windings as shown in Figure 1.1.
Figure 1.1 – 120-volt Single Voltage Connection
BLACK
The AC connection system on air-cooled genera-•
tors uses a GROUNDED neutral.
A separate green ground wire is connected to the •
recreational vehicle’s junction box.
NOTE:
Do NOT connect loads in excess of circuit breaker
ratings.
Section 1 – General Information
Recreational Vehicle Generator