Filter
Top Products
20
OPERATION
To clean:
Install the detergent bottle on the spray wand.
Start the pressure washer and spray the detergent on a dry surface using long, even,
overlapping strokes. To prevent streaking, do not allow detergent to dry on the surface.
To rinse:
Using the desired tip, spray away from the rinsing surface for approximately 10
Start at the top of the area to be rinsed and work down, overlapping the strokes.
MOVING THE PRESSURE WASHER
To move the pressure washer:
Turn the pressure washer off. Point nozzle in a safe direction
and pull trigger to release water pressure.
Disconnect the high pressure hose from the trigger handle.
Tilt the machine toward you until it balances on the wheels then roll the machine to the
desired position.
OPERATING THE PRESSURE WASHER
(See Figure 14.)
Use only detergents designed for pressure washers. Many detergents may require mixing prior
to use. Prepare cleaning solution as instructed on the solution bottle.
Fig. 14
WARNING
NEVER change nozzles without engaging the lock-out on the trigger handle and NEVER point
the wand at your face or at others. The quick-connect feature contains small springs that could
eject the nozzle with some force. Failure to heed this may cause personal injury.
Turn off the pressure washer and shut off the water supply.Pull trigger to release water
pressure.
Engage the lock-out on the trigger handle by pushing the trigger lock button to the right.
Pull back the quick-connect collar.
Push the nozzle into place in the spray wand.
Push the collar forward so that the nozzle is secured properly. Check to see that the nozzle is
secure.
SOAP APPLICATION
Soap is applied under low pressure high volume foroptimum performance
Soap can not be applied under high pressure with this machine