Great Dane GSRKW2352S Lawn Mower User Manual


 
Operating - 7
OPERATING
plastic liner. Always place containers on the ground away from your
vehicle before fueling.
• Remove fuel-powered equipment from the truck or trailer and refuel it on
the ground. If this is not possible, then refuel such equipment with a
portable container, rather than from a fuel dispenser nozzle.
• Keep the nozzle in contact with the rim of the fuel tank or container
opening at all times until the fueling is complete. Do not use a nozzle lock-
open device.
• Never overfill fuel tank. Replace fuel tank cap and tighten securely.
• Replace all fuel container caps securely after use.
• For gasoline engines, do not use gas with methanol. Methanol is harmful
to your health and to the environment.
Handling Waste Product and Chemicals
• Waste products, such as, used oil, fuel, coolant, brake fluid, and
batteries, can harm the environment and people:
• Do not use beverage containers for waste fluids - someone may drink
from them.
• See your local Recycling Center or authorized dealer to learn how to
recycle or get rid of waste products.
• A Material Safety Data Sheet (MSDS) provides specific details on
chemical products: physical and health hazards, safety procedures, and
emergency response techniques. The seller of the chemical products
used with your machine is responsible for providing the MSDS for that
product.
Operating
Daily Operating Checklist
Make sure all necessary guards and shields are safely and securely
attached. Check for loose, missing, or damaged parts.
Remove mower deck belt shields. Clean grass and debris from belt
area.
Remove grass and debris from machine and mower deck.
Remove grass and debris from operator station foot plate, pump drive
belt compartment, hydraulic pump and pump mounting plate.
Test park brake.
Test safety systems.
Check battery.
Check for oil leaks.
Check engine oil and hydraulic oil levels.
Check all belts for damage or cracking.
Check engine air filter.
Check mower level.
Adjust cutting height if necessary.
Check wheel bolt torque. Tighten if necessary.
Check tire air pressure. Check tires for damage or cracking.
Check and adjust speed control linkages and lock.
Avoid Damage to Plastic and Painted Surfaces
• Do not wipe plastic parts unless rinsed first.
• Insect repellent spray may damage plastic and painted surfaces. Do not
spray insect repellent near machine.
• Be careful not to spill fuel on machine. Fuel may damage surface. Wipe
up spilled fuel immediately.
• Prolonged exposure to sunlight will damage the hood surface.
Operator Station Controls
c
Picture Note:
A-Speed Control Bar Lock
B-Speed Control Bar
C-Left Motion Control Lever
D-Right Motion Control Lever
E-Hydrostatic Oil Reservoir Cap and Dipstick
F-Ignition Key Switch
G-Fuel Tank Cap
H-PTO Switch
I-Hour Meter
J-Choke
K-Throttle Lever
L-Park Brake Lever
Miscellaneous Controls
c
A-Free-Wheeling Valves