Filter
Top Products
Service Mower - 34
SERVICE MOWER
• To mount in the high position, mount the levers to the top four holes in
the mounting bracket.
• To mount in the low position, mount the levers to the bottom four holes in
the mounting bracket.
Checking and Aligning Motion Control Levers -
Optional Over the Lap Levers
Check Alignment:
1.Park machine safely. (See Parking Safely in the SAFETY section.)
2.Move both motion control levers (A) from the neutral lock to the neutral
steer position.
3.Check levers for equal alignment.
• Check gap (B) between the levers. The recommended gap is 3-6 mm
(1/8-1/4 in.).
NOTE: If the ends of the levers strike against each other while in the
neutral position, move the levers to the neutral lock position and
carefully bend them outward. Move them back to the neutral position
and check for the recommended gap of 3-6 mm (1/8-1/4 in.).
• If positions of the control levers are unequal, an adjustment is
necessary.
Alignment Procedure
1.Adjust position of motion control levers:
• Loosen cap screws (C).
• Slide both levers forward or rearward to desired position on control
arm until levers are aligned.
• Tighten cap screws.
Adjusting Park Brake
1.Park machine safely. (See Parking Safely in the SAFETY section.)
2.Loosen set screw (A).
3.Turn knob (B) clockwise several times.
4. Tighten set screw down in the lower slot.
5.Test park brake.
Service Mower
Removing and Installing Mower Deck Foot Plate
IMPORTANT: Avoid damage! Due to initial brake wear, the park
brake should be checked and adjusted after the first 25 hours of
use.
A park brake that is adjusted too tightly could damage the
transmission or cause premature brake wear.
CAUTION: Avoid injury! Always operate the mower with the
foot plate installed. Operating with the foot plate removed can
cause serious injury.