Filter
Top Products
Operating - 11
OPERATING
• Be careful not to spill fuel on machine. Fuel may damage surface. Wipe
up spilled fuel immediately.
• Prolonged exposure to sunlight will damage the hood surface.
Operator Station Controls
A- Motion Control Levers
B- Park Brake Lever
C- Seat Adjustment Lever
D- Hourmeter
E- Ignition Key Switch
F- PTO Knob
G- Choke (Carbureted Engines Only)
H- Throttle Lever
I - Mower Deck Lift/Lower Lever
J- Height-of-Cut (HOC) Adjustment Pin
K- Mower Deck Transport Position Lock Lever
Miscellaneous Controls
A- Hydraulic Pump Free-Wheel Valves
Mounting and Dismounting Machine Safely
Do not step on the mower deck when mounting and dismounting the
machine. Mount the machine from the front using the foot plate (A). Park
machine safely (See Parking Safely in the SAFETY section) before
dismounting.
Keep the foot plate clean.
Raising and Lowering Operator Seat
Raising the Seat:
1.Park machine safely. (See Parking Safely in the SAFETY section.)
2.Slide seat to full rear position.
3.Remove two locknuts (A) and capscrews securing the flanges at the
rear of the seat frame (B) to the machine.
4.Lift seat frame and tilt forward until it rests against the hinge stops.
Lowering the Seat:
1.Stand on the side of the machine.
2.Slowly lower seat frame. Secure with cap screws and locknuts, removed
earlier.
3.Adjust seat as necessary for operator comfort.
CAUTION: Avoid injury! The seat is heavy and can cause
injury if it falls. When performing any service function under
the operator seat, make sure the seat is tilted forward and
rests against the hinge stops.