Filter
Top Products
6
2-2 Muffler Guard Installation
Locate the two exhaust diverters (P#J0251 w/ 1-1/4” ID,
P#J0250 w/ 1-3/8” ID) and clamp kit P#(X1046)
provided in the hardware bag. Fasten the correct size
exhaust deflector onto the mower’s exhaust and aim the
exhaust as shown in Figure 2-2. Next, fasten the
exhaust diverter by using the clamp kit.
.
Right and left views are as seen from drivers
perspective.
NOTE:
2-3 Frame Mount Bracket Installation
To mount the frame brackets which support the bagger
unit, you must first remove the existing rear bumper.
This can be done by removing the three bolts and nuts
attaching the bumper to each side. Set the nuts and
bolts aside as they will be used to mount the frame
brackets. See Figure 2-3a for bracket orientation. Mount
the left frame mount bracket (Figure 2-3b) by using three
of the existing bolts and three of the existing nuts.
Tighten nuts and bolts. The right frame mount bracket
will mount along with the PTO arm assembly (Figure 2-
3c). Align the hole pattern on the side of the PTO arm
assembly to the hole pattern on the right frame mount
bracket and mower frame. Place each of the three
remaining bolts one at a time through the PTO Arm
assembly, the right frame bracket and through the
existing holes of the mower frame. Fasten the upper
hole by using (1) 3/8”-16 x 1” HHCS P#(K1191) and (1)
3/8”-16 flange nut P#(K1215). Tighten nuts and bolts.
Figure 2-3a.
Figure 2-3b.
Figure 2-3c.
Left
Right
PTO Arm Assembly
Use 3 Existing Bolts To Mount
PTO Assy. Along With
Right Frame Mount Brkt.
To Tractor’s Frame.
Figure 2-2.
Mower’s Exhaust
Rear Of
Mower
3 Existing
Bolts Here
Exhaust Diverter
Left Frame
Mount Brkt.
Right Frame
Mount Brkt.
Fasten Here With
3/8” x 1” HHCS
3/8” Flange Nut