Filter
Top Products
GB - 13
FILLING FUEL TANK
Add fuel to Fuel Tank as needed. See your Engine
Manual for correct type and grade of fuel.
To add fuel to the fuel tank:
1. Place unit in an open or well-ventilated open area.
2. Stop the engine.
3. Clean the fuel cap and the area around the fuel cap
to prevent dirt from entering the fuel tank. Remove
the cap from the fuel tank.
4. Fill the fuel tank to within 1" (25 mm) below bottom
of filler neck.
5. Replace fuel cap and tighten.
6. Clean up any spilled fuel.
PRE-START
1. Check Safety Interlock System
If this system does not function as described do not
operate until repairs are made.
2. Check Air Cleaner
Check air filter for dirt. Clean as required. See
Maintenance Section.
3. Check Engine Fuel and Crankcase Oil
Check and add fuel if required. Check that engine
crankcase oil is full. Refer to Maintenance Section.
4. Check Tire Pressure
5. Check Hydraulic Fluid Level
6. Adjust Seat
Be sure all controls can be reached safely from
operator’s position.
STOPPING IN AN EMERGENCY
The unit can be stopped immediately at any time by
turning the ignition key to the "Off" position.
STARTING AND SHUT OFF
To start the engine:
1. Make sure the steering levers are in neutral.
2. Put the PTO switch in the “Off” position.
3. Engage parking brake.
4. For models with choke:
If the engine is cold, move the choke control to the
“On” position. If the engine is warm or hot, do not
use choke.
5. Move the throttle to 3/4 “Fast” position. See Engine
Manual for detailed instructions.
6. Put the ignition key in the switch and turn it to the
“Start” position.
7. As soon as the engine starts, release the key.
8. For models with choke:
Move the choke control to the “Off” position from
the “Choke” position. Wait until the engine is
running smoothly before operation.
To stop the engine:
1. Bring the steering levers to neutral. Disengage the
PTO and engage the parking brake.
2. Move the throttle lever to the “Slow” position.
3. Turn the ignition key to the “Off” position.
TO MOW WITH UNIT
Operate the unit only when seated in the operator’s
position.
1. Start the engine. Let the engine warm until it is
running smoothly.
2. Release parking brake.
3. Bring the steering levers to neutral.
4. Slow the engine down to about 3/4 speed.
5. Turn ON the PTO switch to engage the mower.
IMPORTANT: Never engage the PTO if the mower is
plugged with grass or other material. This may cause
damage to the electric clutch.
6. Move throttle control to fast.
7. Move the steering levers forward to obtain a slow
ground speed.
8. To disengage the mower, move the PTO switch to
the “Off” position.
9. When you know how to operate the unit, select a
speed appropriate to your mowing conditions.
PARKING
To park the unit:
1. Bring the steering levers to neutral. Turn off PTO.
2. Move the throttle lever to the “Slow” position.
3. Engage the parking brake.
WARNING: AVOID INJURY. Read and
understand entire Safety section before
proceeding.
CAUTION: Make sure all hardware is tight, all
safety devices are in place and all adjustments
are made correctly.
CAUTION: Read entire Owner/Operator
Manual, Clutch Manual, and Engine Manual
first.
DO NOT attempt to start engine at this time.
WARNING: Move the steering control levers
slowly and keep the throttle control lever at slow
speed until you learn how to operate the unit.