Filter
Top Products
GB - 18
5. Lubricate rubber gasket on new oil filter with clean
hydraulic oil.
6. Spin new oil filter onto filter housing until it makes
contact. Tighten oil filter another 1/2 turn.
7. Add new oil to the oil tank. It will take about 4 quarts.
Use Mobil 1 15W50 synthetic oil for best pump and
wheel motor life.
8. Properly dispose of waste oil.
MOWER BLADES
Remove
1. Turn the engine off. Remove the ignition key. Remove
the ignition wire from the spark plugs.
2. Block mower blades to prevent rotation.
3. Remove the bolts, washers, and blades from the
spindle shafts.
Replace
1. Replace the blades, washers and bolts on the spindle
shafts.
2. Tighten the bolts to a torque of 115-125 lbf-ft
(156-169 N•m).
3. Replace the ignition wire on the spark plugs.
Sharpen the Mower Blades
1. Remove mower blade from unit.
Discard mower blade if:
• More than 1/2 in. (1.27 cm) of metal is removed.
• Air lifts become eroded.
• Blade is bent or broken.
2. Sharpen mower blade by removing an equal amount of
material from each end of mower blade. DO NOT
change angle of cutting edge or round the corner of the
mower blade.
3. Check mower blade balance.
Slide mower blade on an unthreaded bolt. A balanced
blade should remain in a horizontal position. If either
end of mower blade moves downward, sharpen the
heavy end until blade is balanced.
4. Install mower blade(s) on unit.
5. Tighten the bolts to a torque of 115-125 lbf-ft
(156-169 N•m).
BATTERY
Unit comes equipped with a maintenance-free battery that
requires no regular maintenance except cleaning the
terminals.
CAUTION: Use sturdy gloves or padding to protect
hands when working with mower blades.
CAUTION: DO NOT sharpen mower blades while
on unit. An unbalanced mower blade will cause
excessive vibration and eventual damage to unit.
Check mower blade balance before reinstalling
blades.
NEVER weld or straighten bent blades.
Figure 7
992042, 044, 054,
064, 077, 079, 081,
083, 092, 094, 096
992051, 055, 080, 082,
095, 097, 310, 311
WARNING: AVOID INJURY. Read and understand
entire Safety section before proceeding.
WARNING: Battery posts, terminals and related
accessories contain lead and lead compounds,
chemicals known to the State of California to cause
cancer and reproductive harm. Wash hands after
handling.
1. Cutting Edge
2. Square Corner
3. Air Lift Erosion
4. Air Lift
OT0792
Figure 8
DO NOT Sharpen to This Pattern
Sharpen to This Pattern
DISCARD if More
Than 1/2 in. (1.27 cm)
1
1
4
2
4
3