Filter
Top Products
GB - 10
UNIT ASSEMBLY
Package Contents:
Unit, Mower Deck and Literature Pack
Unpack Unit
Remove unit and all other components from shipping
container. Open bypass valves (see MOVING THE UNIT
WITH THE ENGINE OFF on page 15). Push unit from
container onto a level surface. Close bypass valves.
Check Tire Pressure
See SPECIFICATIONS on page 28.
Position Steering Levers
Remove bolts and spacers from steering levers. Flip the
steering levers into operating position. Reinstall spacers,
bolts and nuts. Tighten hardware securely. See Figure 3.
Connect Battery
Connect negative (–) battery cable to battery (see Replace
Battery on page 19 and perform steps 2 through 3 in the
installation section).
Check Engine Oil
Refer to Engine Manual.
Check Hydraulic Oil
See HYDRAULIC FLUID on page 17.
Position Deflector - 60-Inch Decks
Remove, reverse, and reinstall discharge chute and
mounting bracket.
Fill Fuel Tank
See FILLING FUEL TANK on page 14.
Hardware
Check for loose hardware.
Check Safety Interlock System
See Safety Interlock System on page 12.
Level Mower Deck
See Leveling the Mower Deck on page 24.
Check Function of All Controls
Ensure unit runs and performs properly.
ASSEMBLY
WARNING: AVOID INJURY. Read and understand
entire Safety section before proceeding.
1. Steering Lever in
Shipping Position
2. Spacers and Hardware
3. Steering Lever in
Operation Position
OF3520
Figure 3
1
2
3
2
WARNING: Discharge chute must pivot freely. DO
NOT over tighten the pivot bolts.
WARNING: Safety interlock system failure and
improper operation of unit can result in death or
serious injury. Test this system each time unit is
operated. If this system does not function as
described, do not operate until repairs are made.
WARNING: FAILURE OF CONTROLS could result
in death or serious injury.