Global Machinery Company ULB2400 Blower User Manual


 
10
To select the blow operation
1. Move the selector lever
towards the back of the
housing (fig A).
When the blow operation
is selected, air is drawn up
through the large blow/vac
tube and then expelled at a
much higher velocity in the
lower cavity below the blow/
vac tube.
Ensure when the blow operation is selected the blower vac
is pointed, directed and used in a safe manner. Do not
direct the air flow from this blower vac directly or indirectly
towards another person.
To select the vacuum operation
1. Push the selector lever
forward (fig A).
When the vacuum operation
is selected, air and debris is
drawn up through the large
vac tube, and forced through
the mulching impellor.
The debris is mulched and
then blown down into the
collection bag.
Important. Always ensure the collection bag is correctly
attached as per the “Fitting the collection bag” section in
this manual.
Always be aware of what is being drawn up into the blow/
vac tube. This product is only designed for garden debris
like leaves, twigs and garden cuttings.
Important notes when using the
blower/vacuum selector lever
Do not force the lever. The lever should move with very
little resistance. If the lever is difficult to move, disconnect
the power supply, remove the collection bag and ensure
debris, dirt or mud has not jammed the lever.
When selecting either of the operations, ensure the
selector lever is fully in one position or the other, not
half way.
To empty the collection bag
The collection bag is attached to the blower vac in 2
places. It is not necessary to remove the collection bag
from the blower vac when the bag needs to be emptied.
The rear of the bag is fitted with a full length zip.
Simply open the zip and empty the contents.
Ensure to close the zip prior to operating the blower vac.
Tips for using your blower vac
The following points may assist you in the operation of
the blower vac.
Always try and vacuum dry leaves, cuttings or general
garden debris.
Wet material is difficult to mulch and also can cause the
blower vac to clog.
If the leaves etc. are damp, then use the blower vac in
blow selection to pile the leaves etc. into one area, vac
and mulch the leaves when dry.
Avoid using the vac on areas where there are stones,
or other hard objects. These objects will damage the
impellor of the blower vac.
It is also advisable not to allow the blower vac to
pick up soil. Soil generally contains moisture and
when combined with other garden debris can clog the
blower vac.
A
A