Filter
Top Products
1514
Maintenance
This product has been designed to be a low-maintenance tool. However, in order
to maintain its performance, you must ALWAYS follow these simple directions.
1. ALWAYS handle the tool with care. Treat it as you would any optical
device, such as a camera or binoculars.
2. AVOID exposing the self leveling vertical line generator to shock,
continuous vibration or extreme hot or cold temperatures.
3. ALWAYS store the self leveling vertical line generator indoors. When
not in use, ALWAYS store the self leveling vertical line generator in its
protective case.
4. When you are finished using the tool, ALWAYS make sure that the switch
is in “0” position.
5. ALWAYS keep the product free of dust and liquids. Use a damp cloth and
mild soap to clean the tool. If needed, ONLY USE a soft cloth or cotton
swab and glass cleaner to clean the lens.
WARNING: ALWAYS remove the batteries when cleaning lens.
6. ALWAYS clean and thoroughly dry the tool after each use.
7. Check the batteries regularly to avoid deterioration. ALWAYS remove
the batteries from the tool, if it is not going to be used for an extended
period of time.
8. Replace the batteries after approximately 40 hours of use.
9. DO NOT disassemble the self leveling vertical line generator.. This will not
only void the warranty, but could expose the user to hazardous radiation
exposure.
10. DO NOT modify the tool in any way or use the tool with
products and/or accessories not specified in this instruction manual, this
could expose the user to hazardous laser radiation exposure.
11. DO NOT attempt to change any part of the laser lens.
NOTE: This tool is not to be tampered with and should only be repaired by
a qualified Service Technician with laser experience.
Troubleshooting
Problem Possible cause Solution
Laser line
projection is
weak.
Batteries are weak. Replace with fresh batteries.
Laser line is
hard to see
Light in area is too
bright.
Use laser enhancing glasses.
Batteries are weak.
Replace with fresh batteries.
Laser light is
not projected.
Power switch is not
“on”
Check to be sure the power
switch has been pushed
forward and is in the “1”
position.
Laser line
projected is
not upright.
The tool is not placed
on a horizontal surface
or the declining angle
of it is beyond ±3°.
Replace the tool on a
horizontal surface and make
sure the laser line can sway
after the tool is turned on.