Filter
Top Products
1110
Changing the self leveling vertical line generator
batteries
1. Ensure that the self leveling
vertical line generator is
switched OFF by checking that
the laser switch (1) is in the
“0” position
2. Unclip the battery cover (3).
3. Remove and replace both AA
batteries, taking care to insert
the new batteries with the
correct polarity.
4. Replace the battery cover (3) and shut the cover back to the position in
place.
CAUTION. Remove the self leveling vertical line generator when the tool
is to be stored without use for a few days or more. If left in position, the
batteries might leak and damage the laser light assembly. Damage due to
leaking batteries is not covered under warranty.
Operating the self leveling
vertical line generator
1. To switch the self leveling vertical
line generator on, push the laser
switch (1) forward until it stops
in “1” position.
2. To swtich the self leveling vertical
line generator OFF, push the
switch backward until it stops in
“0” position.
WARNING: When turning on the self leveling
vertical line generator ALWAYS be aware of
protecting the eyes of yourself and those
around you. NEVER point the self leveling
vertical line generator at anyone’s face,
including your own.
Failure to heed this warning could result in
serious injury.
Before using the self leveling vertical line
generator, it is important to ensure that the
unit is leveled.
1. Place the unit on a flat surface and check
the bubble vial (2). If the air bubble is
located inside the black circle, then you
can proceed.