Filter
Top Products
14 Genie Lift Part No. 35566
Operator's Manual First Edition • Sixth Printing
Operating Instructions
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
5 Only use the machine as it was intended.
Fundamentals
The Operating Instructions section provides
instructions for each aspect of machine operation.
It is the operator's responsibility to follow all the
safety rules and instructions in the operator's
manual.
Using the machine for any purpose other than lifting
material is unsafe.
If more than one operator is expected to use a
machine at different times in the same work shift,
each operator is expected to follow all safety rules
and instructions in the operator's manual. That
means every new operator should perform a pre-
operation inspection, function tests and a
workplace inspection before using the machine.
Setup
Select an area that is firm, level and free of
obstructions.
Follow the Setup procedures in the Function Tests
section.
Raising and Lowering Load -
Manual Winch
1 Center the load on the forks or load platform.
2 Raise the load by firmly grasping the winch
handle and rotating it clockwise. Do not allow
the cable to wind unevenly onto the winch
drum.
3 Lower the load by firmly grasping the winch
handle and rotating it counterclockwise. After
lowering to the desired position, turn the winch
handle clockwise (raise the load)
1
/4 turn to set
the brake.
Raising and Lowering Load -
Electric Winch
1 Center the load on the forks or load platform.
2 Connect the battery pack.
3 Pull out the red Emergency Stop button to the
on position.
4 Push the up or down button on the hand controls
for the desired direction of travel.