Filter
Top Products
Owner’s Manual for Stationary Emergency Generators 19
Section 4 Operation
4.1 — Control Panel
NOTE: The control panel is intended for use by qualified service personnel only.
The control panel is located behind the viewing window at the rear of the unit.
With the control panel set to AUTO, the engine may crank and start at any time without warning. Such
automatic starting occurs during the programmed exercise cycle or when utility power source voltage
drops below the configured level. To prevent possible injury that might occur during sudden starts,
always set the control panel to OFF, remove the negative battery cable from the negative battery post,
and remove the 7.5 amp fuse before working on or around the generator or transfer switch. For added
security, place a DO NOT OPERATE tag or placard on both the control panel and transfer switch.
Figure 4-1. Generator Control Panel
4.2 — Auto/Manual/Off
Feature Description
AUTO
Press to activate fully automatic operation. Green LED illuminates to confirm that system is in AUTO mode.
Transfer to standby power occurs if utility power fails.
Functionality of exercise timer is enabled, if set.
MANUAL
Press to crank and start engine. Blue LED illuminates to confirm that system is in MANUAL mode.
Transfer to standby power occurs if utility power fails.
Functionality of exercise timer is disabled.
OFF
Press to shut down engine, if running. Red LED illuminates to confirm that system is in OFF mode.
Transfer to standby power does not occur if utility power fails.
*
o
OFF
PUSH TO TRIP
7.5 Amp Fuse
and USB Port
Main Circuit Breaker
ESCAPE
ENTER
AUTO MANUAL OFF
LCD Screen
Control Panel