Filter
Top Products
Generac Portable Products 3,000 PSI High Pressure Washer
6
• Secure handle to the pressure washer using the four
provided flange nuts.
• Slowly tip the pressure washer back in place and insert
the multi–colored nozzles in the spaces provided in the
handle.
Add Engine Oil
Place the unit on a flat, level surface. See engine owner’s
manual for proper oil and fill technique.
NOTE: The pump is pre-lubricated and sealed, requiring
no additional lubrication for the life of the pump.
Add Gasoline
DANGER! Never fill fuel tank indoors. Never fill
fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
WARNING! Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away any
fuel spillage from engine and equipment before
starting.
• Use clean regular unleaded fuel and store in approved
clean covered containers. Use clean fill funnels. Never
use “stale” gasoline left over from last season or gasoline
stored for long periods.
• Clean the area around the fuel fill cap, remove the cap.
Slowly fill tank to the bottom of the filler neck (Figure 2).
• Install the fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT: You must assemble the nozzle extension
to the spray gun and attach all hoses before you start the
engine. Starting engine without all hoses connected and
water supplied will damage the pump.
• Uncoil high pressure hose and attach quick connect end
of hose to the base of the spray gun (Figure 3). Pull
down on the collar of the quick connect, slide onto the
gun and let go of collar. Tug on hose to be sure of a tight
connection.
• Similarly, attach the other end of the high pressure hose
to the high pressure outlet on the pump. Pull down on
the collar of the quick connect, slide onto the pump and
let go of collar. Pull on hose to be sure of a tight
connection.
• Before you connect your garden hose to the water inlet,
inspect the inlet screen (Figure 4). Clean the screen if it
contains debris, replace it if it is damaged. DO NOT
RUN THE PRESSURE WASHER IF THE SCREEN IS
DAMAGED.
• Run water through your garden hose for 30 seconds to
clean out any debris. Turn off water.
Inspect inlet screen. Do Not
use if damaged, clean if dirty.
Figure 4 — Connect Garden Hose to Water Inlet
Connect high
pressure hose
here.
Figure 3 — Connect High Pressure Hose to Spray Gun
Maximum Fuel Level
Figure 2 — Add Gasoline to Fuel Tank