Filter
Top Products
Device Information
Pro Trashbreaker Handheld Device
Specifications
Battery type Rechargeable, replaceable lithium-ion
Battery life 60 hours typical use
Operating temperature range From -4° to 140°F (from -20° to 60°C)
Charging temperature range From 32° to 104°F (from 0° to 40°C)
Storage temperature range From -4° to 104°F (from -20° to 40°C)
Water rating IEC 60529 IPX7*
Wireless range 4 mi. (6.4 km)
*The device withstands incidental exposure to water of up to
1 meter for up to 30 minutes.
Pro Trashbreaker Dog Collar Device
Specifications
Battery type Rechargeable, replaceable lithium-ion
Battery life 40 hours typical use
Operating temperature range From -4° to 140°F (from -20° to 60°C)
Charging temperature range From 32° to 104°F (from 0° to 40°C)
Storage temperature range (up
to 1 month)
From -4° to 122°F (from -20° to 50°C)
Storage temperature range (up
to 3 months)
From -4° to 95°F (from -20° to 35°C)
Water rating Up to 1 ATM*
*The device withstands pressure equivalent to a depth of
10 meters.
Checking the Battery Level
Turn on the dog collar device (Turning On the Dog Collar
Device).
The status LED flashes every few seconds while the device is
on. The color of the status LED indicates the battery charge
level.
Green The battery has a good charge.
Yellow The battery should be charged soon.
Red The battery is very low and should be charged
immediately.
Flashing Red The battery is depleted and must be charged. Training
features are disabled.
Replacing the VHF Antenna in the Dog
Collar Device
Before you replace the VHF antenna, you must remove all dirt,
water, and debris from the device. You also need a small
Phillips screwdriver and a larger Phillips screwdriver.
1
Remove the three screws
À
from the cover over the VHF
antenna.
2
Pry off the cover.
3
Remove the screw
Á
securing the VHF antenna to the back
plate.
4
Pull the length of the antenna from the antenna guide to
remove the old antenna.
5
Loop the antenna guide around the collar strap, and thread
the new VHF antenna through the guide.
This helps to point the antenna up.
6
Replace the screw securing the VHF antenna to the back
plate.
7
Replace the cover over the VHF antenna.
8
Replace the three screws on the cover.
Pro Trashbreaker Battery Replacement
Instructions
WARNING
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use a sharp object to remove batteries.
CAUTION
Contact your local waste disposal department to properly
recycle the batteries.
Pro Trashbreaker Handheld Device Components
À
Security screws
Á
Back plate
Â
Battery plate screws
Ã
Gasket
Ä
Battery plate
Å
Battery
Replacing the Pro Trashbreaker Handheld Device
Battery
Before you replace the battery, you must remove all dirt, water,
and debris from the device. You also need a small Phillips
screwdriver and the security screwdriver included with the
battery replacement kit.
You can purchase a replacement battery at
http://buy.garmin.com. You should use only an official Garmin
®
replacement part.
1
Remove the eight security screws from the back of the
device.
2
Lift up the back plate.
3
Grip the battery connector wires close to the connector, and
pull the connector perpendicular to the circuit board to
disconnect the battery connector from the device.
4 Device Information