Filter
Top Products
Getting Started
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Setting Up the Pro Trashbreaker System
Before you can use the Pro Trashbreaker system, you must set
up the devices.
1
Attach the dog collar device to the collar strap (Attaching the
Dog Collar Device to the Collar Strap).
2
Charge the handheld device (Charging the Handheld
Device).
3
Charge the dog collar device (Charging the Collar).
4
Turn on the devices (Turning On the Dog Collar Device).
5
If necessary, pair the dog collar device with the handheld
device (Pairing a Dog Collar Device with the Handheld
Device).
Device Overviews
Pro Trashbreaker Handheld Device
À
Intensity level and training mode dial
Á
Battery level
Â
Dog collar device toggle switch
Ã
Training keys
Pro Trashbreaker Dog Device
À
Power key
Á
Status LED
Â
Lights
Ã
Contact points
Ä
Charging clip contacts
Attaching the Dog Collar Device to the Collar
Strap
1
With the buckle
À
facing outward, insert the end of the collar
strap through the slot
Á
on the collar device.
2
Pull most of the collar strap through the two slots
Â
on the
dog device.
3
Insert the end of the collar strap through the slot
Ã
on the
opposite side of the device.
4
Pull the strap until it is tight across the front of the device.
5
Wrap the antenna keeper
Ä
around the collar strap.
6
NOTE: Do not bend the antenna sharply. You should
lengthen the collar strap on the side with the antenna keeper
to avoid bending the antenna sharply.
Slide the antenna
Å
through the antenna keeper.
Charging the Handheld Device
You should fully charge the battery before you use the device
for the first time or whenever the battery is low (Checking the
Battery Level). It is normal for the battery to discharge in
approximately 7 to 10 weeks when the device is not in use.
Charging a fully depleted battery takes about 2 hours.
NOTE: The device will not charge when it is outside the
temperature range of 32° to 104°F (0° to 40°C).
1
Lift the weather cap
À
.
2
Plug the small end of the power cable into the mini-USB port
Á
on the device.
3
Plug the other end of the power cable into an appropriate
power source.
The status LED is solid red when the device is charging.
4
After the status LED turns solid green, unplug the power
cable from the device.
Getting Started 1