Gardena R40Li Lawn Mower User Manual


 
8 - English
1. INTRODUCTION AND SAFETY
1.4 Safety Instructions
Use
This robotic lawnmower is designed to mow
grass in open and level ground areas. It may
only be used with the equipment recommended
by the manufacturer. All other types of use are
incorrect. The manufacturer’s instructions with
regard to operation, maintenance and repair
must be followed precisely.
The robotic lawnmower may only be operated,
maintained, and repaired by persons that are fully
conversant with its special characteristics and
safety regulations. Please read the Operator’s
Manual carefully and make sure you understand
the instructions before using the robotic
lawnmower.
It is not permitted to modify the original design of
the robotic lawnmower. All modifications are made
at your own risk.
Check that there are no stones, branches, tools,
toys or other objects on the lawn that can damage
the blades and cause the mower to stop.
Start the robotic lawnmower according to the
instructions. When the main switch is in
position
1
, make sure you keep your hands and
feet away from the rotating blades. Never put your
hands and feet under the robotic lawnmower.
Never lift up the robotic lawnmower or carry it
around when the main switch is in position
1
.
Do not let persons who do not know how the
robotic lawnmower works and behaves use the
robotic lawnmower.
Never use the robotic lawnmower if persons,
especially children, or pets, are in the immediate
vicinity.
Do not put anything on top of the robotic
lawnmower or its charging station.
Do not allow the robotic lawnmower to be used with
a defective blade disc or body. Neither should it be
used with defective blades, screws, nuts or wires.
Do not use the robotic lawnmower if the main
switch does not work.
Always switch off the robotic lawnmower using the
main switch when the robotic lawnmower is not in
use. The robotic lawnmower can only start when
the main switch is set to
1
and the correct PIN
code has been entered.
The robotic lawnmower must never be used at the
same time as a sprinkler. In this case use the
timer function (see
6.3 Timer
on page 44) so the
mower and sprinkler never run simultaneously.