Gardena 8882 Trimmer User Manual


 
20
GB
G
F
ATTENTION ! Damage to the hedge trimmer!
A
V Never clean the hedge trimmer under running
water or with a water jet (in particular a high
pressure water jet).
1. Clean the hedge trimmer with a damp cloth.
2. Lubricate the trimmer blade
G
with a low viscosity oil (e.g.
GARDENA spray-oil Art. 2366). Avoid contact of the oil with
the plastic parts and wear gloves.
8. Troubleshooting
DANGER ! Risk of physical injury!
A
Cutting injuries can be caused if the hedge trimmer
does switch on unintentionally.
V Remove the battery before troubleshooting
(see 4. Initial Operation) and slide the protective
cover
F
over the cutter blade
G
.
Fault Possible cause Remedy
Hedge trimmer does not start Battery is flat. v Charge battery (see
4. Initial Operation).
Battery not pushed onto v Push battery onto the handle
the handle properly. and make sure that the
locking buttons snaps in
correctly.
When rotating the cutting unit, it v When rotating the cutting
was not engaged at 0° or 90°. unit, engage it at 0° or 90°.
When tilting the swivel head, it v When tilting the swivel head,
was not engaged between 75° engage it between 75° and
and -45°. -45°.
Hedge Trimmer does not Hedge Trimmer overheats. v Let Hedge Trimmer cool for
start / starts only briefly 30 seconds.
Hedge is not cleanly cut Blade blunt or damaged. v Have blade replaced by
GARDENA-Service.
Charging indicator lamp does Battery not plugged in v Plug in battery charger and
not light up properly. charging cable properly.
Charging indicator lamp A fault has occurred. v Unplug and reinsert
flashes for more than charging cable.
The fault
1 hour
will be reset.
The battery can no longer Battery is defective. v Replace the battery
be charged (Art. 8835 / 8839).
Only the original GARDENA Replacement Battery 18 V
(Art. 8835 / 8839) may be used. This can be obtained from
your GARDENA dealer or directly from GARDENA Service.
Telescopic tube slips despite Nut/s loose on clamping lever/s. v Tighten nut/s on clamping
clamped clamping lever /s lever/s using a 10 mm
spanner.
G
F