Filter
Top Products
Line Feed
• WARNING
• Wear eye protection.
Do not lean over the trimmer whilst trim-
ming, objects may be thrown by the cutting
line.
Do not allow cutting head to rest on the
ground.
Do not overload your trimmer.
Overloading can be avoided by making
sure the motor speed does not drop undu-
ly.
DISCONNECT FROM THE MAINS ELEC-
TRICITY SUPPLY BEFORE ATTEMPTING
ANY MAINTENANCE OR ADJUSTMENT.
• BEFORE USE
Make sure that both lines are fed out.
• Make sure motor is up to full speed before
trimming.
• The switchbox is provided with a lock-off
button (L1) to prevent accidental starting.
1. To start, press lock-off button (L1), squeeze
the switch lever (L2), release lock-off button.
2. Cut with nylon line at an angle using the tip.
(M)
3. Swing trimmer in and out of the cutting area
taking small cuts (N)
4. To feed out nylon line, see the Line Feed sec-
tion above.
5. To stop your trimmer release the switch lever.
L
N
Use
The length of nylon line wears down naturally
as you work.
When this happens, tap the Cap (K1) on the
ground while it is turning. A further length of
line will automatically be fed out.
The line cutter in the guard then ensures the
line is cut to the optimum length.
IMPORTANT:- Too much line reduces motor
speed and cutting performance.
AUTO
K
line cutter
1
2
M
1