Filter
Top Products
Steady Handle Assembly
1. Remove the Wing Knob (A1) and Bolt (A2)
from the Steady Handle (A3).
2. Locate the Steady Handle (B1) onto the tube.
Insert the Bolt (B2) through the Steady Handle
and the Cable Management (B3) and secure
with the Wing Knob (B4).
3. Adjust the Steady Handle to the most comfort-
able operating position by loosening the Wing
Knob and moving the handle up or down the
tube.
Safety Guar
d Assembly
1. Remove the Nut (C1) and Bolt (C2) from the
Safety Guard (C3).
2. Remove the Cap (D1) and Spool Holder (D2)
from the tube.
3. Locate the Safety Guard (E1) onto the tube.
4. Secure the Safety Guard with the Bolt (F1)
and Nut (F2).
5. Replace the Spool Holder (G1) and Cap (G2).
Tighten the Cap to secure.
Cable Restraint
1. Form loop in mains cable and push the loop
through the slot (H1).
2. To secure, position loop over the hook and pull
the cable back through the slot (H2).
Line Cutter Cover
1. Remove the cover on the Line Cutter (J),
enabling the nylon line to be cut to its optimum
length when the product is in use.
Assembly Instructions
D
C
A
E
B
H1 H2
1
2
3
1
2
3
4
1
2
3
1
2
F
1
2
G
1
1
2
J