Filter
Top Products
J1
J2
Assembly Instructions cont’
Line Feed
• WARNING
• Wear eye protection.
Do not lean over the trimmer whilst trimming,
objects may be thrown by the cutting line.
Do not allow cutting head to rest on the ground.
Do not overload your trimmer.
Overloading can be avoided by making sure
the motor speed does not drop unduly.
DISCONNECT FROM THE MAINS ELEC-
TRICITY SUPPLY BEFORE ATTEMPTING
ANY MAINTENANCE OR ADJUSTMENT.
• BEFORE USE
Make sure that both lines are fed out.
• Make sure motor is up to full speed before
trimming.
• The switchbox is provided with a lock-off
button (N1) to prevent accidental starting.
1.To start, press lock-off button (N1), squeeze the
switch lever (N2), release lock-off button.
2. Cut with nylon line at an angle using the tip. (P1)
3. Swing trimmer in and out of the cutting area
taking small cuts (P2)
4. To feed out nylon line, see the Line Feed
section above.
5. To stop your trimmer release the switch lever.
N
P2
Use
The length of nylon line wears down naturally
as you work.
When this happens, tap the Cap (M1) on the
ground while it is turning. A further length of
line will automatically be fed out.
The line cutter in the guard then ensures the
line is cut to the optimum length.
IMPORTANT:- Too much line reduces motor
speed and cutting performance.
AUTO
M
line cutter
1
2
P1
K1
1
K2
L
Cable Restraint
1. Form loop in mains cable and push the loop
through the slot (J1).
2. To secure, position loop over the hook and pull the
cable back through the slot (J2).
Adjustable Shoulder Har
ness
1. Attach the clip on the Shoulder Harness to one of the
holes in the Shoulder Harness Location (K1) to enable
the correct and most comfortable balance when using the
product with the harness fitted across the body (K2)
Line Cutter Cover
1. Remove the cover on the Line Cutter (L), enabling
the nylon line to be cut to its optimum length when
the product is in use.