Flymo 1000XT Trimmer User Manual


 
Carton Contents
IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
IF ANY P
ARTS ARE MISSING CONTACT:-
Husqvarna Outdoor Products Customer Service Department direct:-
Telephone : 0870 609 1901 Fax : 0870 609 1902
Safety
General
1. Never allow children or people unfamiliar with these
instructions to use the product. Local regulations
may restrict the age of the operator.
2. Only use the product in the manner and for the
functions described in these instructions.
3. Never operate the product when you are tired, ill or
under the influence of alcohol, drugs or medicine.
4. The operator or user is responsible for accidents or
hazards occurring to other people or their property.
5. This product is intended to be used by a standing
operator, primarily for cutting grass and other
ground level plants.
Electrical
1. The British Standards Institute recommend the use
of a Residual Current Device (R.C.D.) with a tripping
current of not more than 30mA. Even with a R.C.D.
installed 100% safety cannot be guaranteed and
safe working practice must be followed at all times.
Check your R.C.D. every time you use it.
2.
Before use, examine cable for damage, replace it if
there are signs of damage or ageing.
If not used properly this product can be dangerous! This product can cause serious injury to the opera-
tor and others, the warnings and safety instructions must be followed to ensure reasonable safety and
efficiency in using this product. The operator is responsible for following the warning and safety instruc-
tions in this manual and on the product.
Explanation of Symbols on the product
Warning
Read the user instructions carefully to
make sure you understand all the con-
trols and what they do.
Keep others, including children, pets and
bystanders outside the 10 metre hazard
zone. Stop the product immediately if you
are approached.
Wear eye protection
To avoid the possibility of electric shock,
do not use in damp or wet conditions.
Switch off! Remove plug from mains
before adjusting, cleaning or if cable is
entangled or damaged.
Warning: The cutting line continues to rotate after the
machine has been switched off.
360º
10m
Electric Cable with
moulded on plug
Guard (with
bolt and nut)
Instruction
Manual
Adjustable
Shoulder
Harness
Cable
Management
Cable
Management
Hexagon
Drive Tool
Handle
Clamp
Switch
Handle
Steady
Handle
Shoulder
Harness Location
Lock-off
button