Fisher-Price H7185 Swing Sets User Manual


 
• Locate the R and L on the underside of each elbow foot.
The R indicates the right leg. The L indicates the left leg.
• While pressing the upper button on the right leg, fit it into
the tube in the motorized frame. Make sure the upper
button on the right leg “snaps” into the hole in the tube.
• Repeat this procedure to assemble the left leg to the
motorized frame.
• When the legs are assembled correctly to the tubes in the
motorized frame, you should not see the red dots.
Tube
Hole
Red Dot
Motorized Frame
Button
Elbow Foot
L
R
• Stand the assembly upright.
• Pull the legs out so that the buttons “snap” into the holes in
the motorized frame.
• When standing behind the product, all four feet should be flat
upon the floor. And, check for an L marking on the left foot
and an R marking on the right foot.
• If the feet are not flat upon the floor, or the left and right feet
have been reversed, remove both lower legs from the upper
legs. Replace them onto the opposite upper leg.
Feet
Feet
Button
Button
L
R
• Position the seat upright.
• Place the pad onto the seat with the ruffle toward the top
of the seat.
• Fold the bottom of the pad up. Insert the crotch belt through
the slot in the pad. Make sure the crotch belt is not twisted.
Crotch Belt
Slot
Ruffle
Seat
Assembly
• Fold the top of the pad down.
• Insert the two elastic loops on the pad through the holes in
the seat bottom.
• While holding the elastic loops in place, turn the seat
face down.
• Hook the elastic loop on the left side onto the peg on the
right side.
• Hook the elastic loop on the right side onto the peg on the
left side.
Elastic
Loops
Hole
Hole
Elastic
Loops
Peg
Hint: The elastic loops should cross over each other when
attached correctly to the pegs.
Bottom View
5
6
7
8
5